Drain Master for Industrial Use
Manufactured by Drain Master Industries

Product Data Sheet

DESCRIPTION

Full flow 3" ABS gate valve adapts to 3" ABS male or female bolt on specific flange fittings. Can be adapted to most pipe sizes with proper fittings and space requirements. Special seals required for sealing between valve and flanges. Gate opens/closes in less than 2 seconds. Indicator light for open or closed position sensing available. DPDT momentary switch is necessary for reversing polarity to motor, can also be controlled with relays and timing circuits. Low pressure (4 psi) applications for transfer of water, air, or vacuum.
Equipped with manual override for emergency opening or closing.

ELECTRICAL

LED OPERATION

Reed switch activated with magent. Max current - 1/2 AMP.
For gate positioning - fully open or fully closed.

PLUMBING

Valve Installation - good plumbing practices must be followed. Piping should be installed in such a way that the valve is not put in a bind. Access to the valve is necessary for use of manual override and valve replacement when necessary. The valve should have clearance all around. When gluing near valve, care must be taken not to get glue on the gate. All piping must be properly supported. The valve cannot support the piping.

SEALS

MECHANICAL OPERATION

A series of gears allow for a 50:1 gera reduction, developing the necessary torque.

A manual override is accessible from either side of the valve. It is located within the dome area.

To activate override, a 1/8” allen wrench is included. There are directional arrows for

open/close. Gate is fully opened or closed with a turn and a half on the hex head. The hex head is

anodized aluminum and can be damaged if improperly used.

MATERIALS

ABS plastic, aluminum, stainless steel, acetal, brass, Buna N. anodized aluminum.

LUBRICATION

Dow Corning 111

WARRANTY

PFI warrants all products to be free from defects in materials and workmanship for a period of 1 year from the date of purchase. This warranty does not include damage to products resulting from accident, misuse, improper installation and unauthorized alterations. PFI's warranty obligation shall be limited to replacement of the product with a new valve (not reconditioned), which will be your exclusive remedy under this warranty. PFI shall not be liable for any special, incidental, indirect or consequential damages whatsoever (including, without limitation, labor or installation charges, damages for loss of business profits, business interruption or any other pecuniary loss) arising out of the use or inability to use the product.

Tech Support - Toll Free 877-787-8833

Last Updated Tuesday, July 07 2009 @ 02:23 AM UTC|7,638 Hits